Repairs
Repair & Maintenance
Should the door leave the ground unevenly, catch at the same spot every time, or bang when it lands, the cause is usually mechanical and usually modest. Track alignment, roller condition and balance are the first three things we check.
Which one do I need?
- You moved in three months ago.Garage Door Safety Inspection
- Since the first cold snap the door has been sluggish.Garage Door Tune-Up
- There was a loud bang from the garage, then silence.Off-Track Garage Door Reset
- From outside, the horizontal groove between two sections now steps sideways by a centimetre.Garage Door Panel Replacement
- Every mild afternoon the snow melts off the car, runs to the door, and by morning the rubber strip along the bottom is frozen to the concrete.Garage Door Bottom Seal Replacement
- Dry leaves keep appearing in the same corner inside the garage, and this fall there were mouse droppings along the wall beside the door.Garage Door Perimeter Weatherstrip
Repair & Maintenance
Inspection, adjustment, sealing, and section-level repairs.
Garage Door Safety Inspection
Watching one full cycle under power
Before anything is measured, the technician stands back and runs the door through a full open and close, listening as much as watching. A healthy door sounds even from bottom to top; a knock at the turn into the horizontal track, a squeal at a particular hinge, a grinding drum or a motor that changes pitch under load each point somewhere specific. The eyes follow both bottom corners to see whether they leave the floor together, the top section as it passes the curve, and the final inch of closing, where the door should settle onto its seal without a thud.
This one cycle often tells the technician where to spend the rest of the visit.